Battery Terminal Clamp And Battery Terminal, Cleaning

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Torque Wrench 1331 5-50Nm:VAG1331
Contact Surface Cleaning Set:VAS6410

The :VAS6410 makes optimal repair quality possible in the realm of vehicle electronics. Using the tools, service work can be performed in the area of the contact sensor on the threaded connection wiring harnesses in the high current circuit (starter and charging current). The :VAS6410 is adapted to the vehicle structural measurements and ensures correct servicing and a comfortable procedure.

NOTE:

The illustrations of the service work only serve as examples.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Do not use rust remover, contact spray or grease because the lack of friction will cause the torque to be exceeded when installing and this will lead to the threaded connection breaking.

WARNING:

Risk of injury. Follow all Warnings and Safety Precautions. Refer to WARNINGS AND SAFETY PRECAUTIONS .

-- Disconnect battery.

-- Check the battery terminal and the battery post for corrosion or dirt.

-- The battery terminal clamp is cleaned with the battery terminal cleaner wire brush using circular motions.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- The battery terminal is cleaned with the bottom side of the terminal cleaner using circular motions.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

WARNING:

Risk of injury. Follow all Warnings and Safety Precautions. Refer to WARNINGS AND SAFETY PRECAUTIONS .

-- Reconnect the battery and tighten the terminals to the specified torque.

NOTE:

Optimal contact is ensured if the bolted components are tightened to the specified torque after cleaning.