Starter, 4.2L TDI 250 Kw, Automatic Transmission Ag8, Removing And Installing: Removing:

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine support. Refer to ENGINE MOUNT, REMOVING AND INSTALLING [For engine(s) CATA] .

-- Remove the right engine support. Refer to ENGINE MOUNT, REMOVING AND INSTALLING [For engine(s) CATA] .

-- Remove the nut -2- and the B+ wire -1- from the threaded connector.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nut -3- and the terminal 50 wire -4- from the threaded connector.

-- Remove the bolt -1- and the ground wire -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the lower starter bolt -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the upper starter bolt -1- on the transmission side. Then remove the starter from the engine.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.