Battery Data, Adapting
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Always follow the procedure described in service informationwhen connecting the battery. The battery cut-out will be deactivated and damage to the vehicle electrical equipment may occur if the connecting sequence is not followed exactly. Refer to BATTERY .
- Observe notes for threaded connections of battery terminals. Refer to BATTERY POST/TERMINAL .
The battery data of the new battery must be entered into the data bus on board diagnostic interface control module after installing a new battery.
-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER .
-- In the Vehicle Diagnostic Tester, select "Guided Fault Finding".
-- Using the "Go to" button, select the "function/component selection" and the following menu options in sequence:
- Body
- Electrical Equipment
- 01 - On Board Diagnostics (OBD) - capable systems
- 19 - Diagnose interface for data bus
- 19 - Data Bus OBD Interface functions
- 19 - Adapt battery data