LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1261 (Charging System (Battery, Starter, Generator) & Cruise Control) >> 27 Battery, Starter, Generator, Cruise Control >> Battery Jump Start Terminal >> Jump Start Point, Removing And Installing >> Removing:

Jump Start Point, Removing And Installing: Removing:

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Always follow the procedure in the service informationwhen disconnecting the battery. The battery cut-out will be deactivated and damage to the vehicle electrical equipment may occur if the connecting sequence is not followed exactly. Refer to BATTERY .

-- Disconnect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Unlock the latch -arrow- and open the cover -1-.

GWWN27-10875Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nuts -2- (13 mm) and the wire -3-.

GWWN27-10876Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the positive pole -1- (17 mm) and the positive cable underneath it.

-- Remove the bolt -4-.

-- Remove battery jump start terminal housing from the bracket. Be careful of the wires still connected.

-- Open both latches -arrows- and remove the cover -1-.

GWWN27-10877Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nut -1- (4 Nm  ) and the wire -2- from the connector thread.

GWWN27-10878Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Open both tabs -arrows- on the bottom and remove the B+ wire connecting piece -1- from the battery jump start terminal housing.

GWWN27-10879Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the battery jump start terminal housing.

scientia non olet · About LEMON Manuals