Battery Interrupt Igniter -N253-, Removing And Installing: Removing:

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Always follow the procedure in the service informationwhen disconnecting the battery. Failure to follow the sequence can trigger the battery cut-off relay and damage the electrical equipment.

-- Disconnect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the bolt -1-, disconnect the 3 connectors -2- and remove the cover -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nut -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nuts -3- (depending on the vehicle equipment level) and wires -4-.

-- Open the latches -arrows- and remove the cover from Fuse Panel D -SD- -1-.

-- Remove the nuts -3- and the Battery Interrupt Igniter -N253- -2-. Be careful of the different wires still connected.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release and disconnect the connector -1- and remove the Battery Interrupt Igniter -N253- -2-.