Distance Regulation Control Module -J428-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Removing and installing the Distance Regulation Control Module -J428- is the same as for Distance Regulation Control Module 2 -J850- and is described for one control module only.

-- Turn off the ignition and all electric consumers and remove the key.

-- Remove the front bumper cover. Refer to CRUISE CONTROL SYSTEM .

-- Release and disconnect the connector -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nut -1- (20 Nm) and both bolts -4- (20 Nm) and then remove the Distance Regulation Control Module -J428- -3- together with the bracket.