Stabilizer Bar Mount, Removing And Installing: Removing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Vehicles With An Air Spring Shock Absorber

-- Activate the vehicle lift mode and place the vehicle on the lifting platform. Refer to VEHICLE LIFT MODE .

Continuation For Both Vehicles

-- Remove the noise insulation below the engine/transmission. Refer to NOISE INSULATION .

Vehicles With V6 TDI Engine

NOTE:

In vehicles with a V6 TDI engine, a damper is installed on the right side.

-- Pry the cap -1- off of the damper -2- and unscrew the securing bolt.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the damper -2- from the stabilizer bar clamp.

Continuation For All Vehicles

-- Unscrew the bolts -arrows- for the stabilizer bar clamp -1- on the subframe.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the stabilizer bar clamp -1-.

The Two Mount Halves are Engaged In One Another Via Retaining Tabs.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Carefully unclip both retaining tabs -arrows- from the stabilizer bar mount -1-.