SUBFRAME, Bonded Rubber Mount In The Forward Direction Of Travel For V8 Engines, Repairing: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following:

Install the driveshaft. Refer to DRIVESHAFT [For transmission(s) 0C8] .

-- Install the subframe with new bolts -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

It must be ensured that the thrust washer -2- is in the correct installation position.

-- The open side -arrow- of the thrust washer -2- must point opposite the direction of travel.

-- When tightening the bolt -arrow-, hold the thrust washer -3- in place using a Counterhold - Multiple Use:T10172A .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Counterhold - Kit - Multiple Use:T10172
Counterhold - Kit - Adapter 10:T10172/10
Thrust Washer

-- Install the universal joint -1- on the steering gear and tighten the bolt -arrow- to the specified torque.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If present, bolt the heat shield -1- to the steering gear -2- -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.