LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1259 (Front Suspension) >> 40 Front Suspension >> Front Wheel Suspension, Lower Control Arm, Upper Control Arm >> Wheel Bearing Housing, Removing And Installing >> Installing

Wheel Bearing Housing, Removing And Installing: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following: 

-- Pull in the drive axle.

GWWN40-10507Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. Driveshaft Fitting Tool:T10206 

-- Loosen the 12-point nut for the drive axle on the wheel hub. Refer to TWELVE-POINT NUT OF DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .

-- Install the wheel and tighten. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

scientia non olet · About LEMON Manuals