Tightening The TENSIONING Clamp On The Larger Diameter

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Attach the Clamping Pliers:VAG1682A as illustrated. When doing this, make sure that edges of clamping pliers are seated in corners -arrows B- of clamp.

-- Tension clamp by turning spindle with a torque wrench (do not tilt clamp tool).

NOTE:

The hard material of the CV boot (compared to rubber) makes it necessary to use a stainless steel hose clamp. It is only possible to tighten the hose clamp with Clamping Pliers:VAG1682A .

Tightening specification: 25 Nm.

Use torque wrench with adjustment range 5 to 50 Nm (for example Torque Wrench 5-50Nm:VAG1331 ).

Make sure the threads on the spindle -A- on the pliers move easily. Lubricate with MOS 2 grease, if necessary.

If it does not move freely, for example due to dirt in thread, the required clamp tension will not be achieved at the specified torque.