Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Release Button Removing/Installing

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert the release button -1- into the rear lid.

-- Install the protective cap -2- on the release button -1-.

-- Tighten the bolts -3-. Tightening Specification: 6 Nm

-- Depending on the equipment, connect the harness connectors -4 and 5-.

Perform a function test on the unlocking components before closing the rear lid.