Removing And Installing The License Plate Holder: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

With Holes Present

-- Install the license plate holder -1- and press in the clips -2-.

With no Holes Present

NOTE:

Drill 12 mm holes.

-- Center the license plate holder -1- with respect to the emblem.

-- Set the drill stop depth to 12 mm and drill the necessary number of holes.

-- Position the license plate holder -1- on the bumper cover -3- and push in the clips -2-.