Overview - Battery, Transceiver, Fuse And Wiring Harness
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
- 1 -Positive Connection
- Red wire with suitable connection
- 2 -To Terminal 15a
- Connection to terminal 15a. Refer to the appropriate Wiring Diagram(s).
- Ensure that this wire is protected by a fuse.
- Fuse: maximum 15 A
- 3 -Antenna Ground
- Ensure that there is a good ground connection to the body.
- The antenna installation location must be treated with suitable corrosion protection.
- 4 -Transmitting/Receiving Antenna
- Component locations: table. Refer to TRANSMITTED OUTPUT, ANTENNA INSTALLATION LOCATIONS .
- 5 -Shielded Antenna Wire
- Wire with coaxial connector
- 6 -Telephone or Two-Way Radio Transmitter/Receiver Unit
- 7 -Wiring Harness
- Voltage supply, positive side through a red wire with 2.5 mm 2 cross section.
- Voltage supply, negative side through a brow wire with 2.5 mm 2 cross section.
- If necessary wire to terminal 15a through a black wire with 1.5 mm 2 cross section.
- 8 -Fuse Panel
- Install next to battery.
- 9 -To the Starter
- 10 -Battery
- Installation location in engine compartment.
- 11 -Negative Wire
- 12 -Body Ground