Removing

WARNING: This page is about a different car, the 2012 Volkswagen Touareg and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Follow the guidelines for a clean working environment when working on the fuel system. Refer to CLEAN WORKING CONDITIONS AND FUEL SYSTEM WORK INSTRUCTIONS .
Always follow these rules before and during work.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Loosen the hose clamp to remove the air guide hose -3- .

Fig 1: Identifying Oil Dipstick -1-, Bolts -2-, Hose Clamp -3- And Harness Connector -4-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolt -2- and disconnect harness connector -4- .

-- Remove the Throttle Valve Control Module -J338- -item 5- .

NOTE:

Ignore -item 1- .

-- Remove the bolts -arrows- and the clamps.

Fig 2: Identifying Union Fittings -1 And 4-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the union nuts -1 and 4- and remove the high pressure line.

NOTE:

Ignore -items 2 and 3- .

-- Remove the engine cover bolts -1 and 2- .

-- Remove the bolts -arrows- and the intake manifold upper section.

Fig 3: Identifying Bolts -Arrows-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.