Removing

WARNING: This page is about a different car, the 2012 Volkswagen Touareg and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Follow the guidelines for clean working conditions when working on the fuel system. Refer to CLEAN WORKING CONDITIONS AND FUEL SYSTEM WORK INSTRUCTIONS .

Always follow these instructions before and during work.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Before removing, clean the threaded area around the fuel pressure sensor using a commercially available detergent. Dirt must not enter the hole in the high pressure reservoir.

NOTE:

Clean carefully, cleaner must not enter the connector.

-- Dry the Fuel Pressure Sensor -G247- .

-- Disconnect the connector from the Fuel Pressure Sensor -G247- .

-- Remove the Fuel Pressure Sensor -G247- .

-- Suction any dirt out of the hole in the high pressure reservoir, the threads and the sealing surface. Do not use mechanical tools.

NOTE:

Seal the hole in the high pressure reservoir immediately with a suitable plug to prevent dirt from entering.