Turbocharger Control Module 1 -J724-, Removing And Installing: Notes
WARNING: This page is about a different car, the 2012 Volkswagen Touareg and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- E-Positioner Service Kit - E-Box:VAS6395/1
- Turbo E-Positioner Service Kit - Connection Cable:VAS6395/4-2
- Turbo E-Positioner Service Kit - Open End Spanner:VAS6395/4-3
NOTE:
Hose connections are secured by clamps and retaining clips.
Charge air system must be properly sealed.
Replace the self-locking nuts.
After installing turbocharger, let engine run at idle for approximately 1 minute and without increasing engine speed. This ensures that charger is lubricated.