Vibration Damper, Removing And Installing: Installing:

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Check the rubber connection between the inner ring and outer ring on the vibration damper for cracks and flaking. Replace the vibration damper if the rubber connection is damaged.

-- Replace the vibration damper bolts.

-- Position the vibration damper and tighten all securing screws by hand.

-- Secure the vibration damper with the : T10172A .

-- Tighten the bolts.

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .