Connecting Rods, Checking Radial Clearance: Procedure:
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the connecting rod bearing cap.
-- Clean the bearing cap and pin.
-- Place the Plastigage® over the entire width of the bearing journal or into the bearing shells.
-- Mount the connecting rod bearing cap and tighten the old bolts to 50 Nm without tightening further. Do not turn crankshaft.
-- Install the connecting rod bearing cap.
-- Compare the width of Plastigage® with the measuring scale.
Radial clearance:
- New: 0.010 to 0.052 mm.
- Wear limit: 0.12 mm.
-- Replace the connecting rod bolts.