Balance Shaft, Removing And Installing: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications. Refer to OVERVIEW - BALANCE SHAFT .
Crankshaft -1- secured in "TDC" using Crankshaft Locking Pin:T40069 .

Fig 1: Crankshaft Locking Pin T40069
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Install in reverse order of removal while noting the following:

NOTE:

The balance weights can only be positioned one way on balance shaft.

-- Install the power take-off drive chain. Refer to DRIVE CHAIN BALANCE SHAFT, REMOVING AND INSTALLING .

-- Install the lower timing chain cover. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .

-- Install the belt pulley side sealing flange. Refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .