Right Timing Chain Cover, Removing And Installing: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace the bolts for the right timing chain cover.

-- Remove old sealant form the grooves in the timing chain cover as well as from the sealing surfaces.

CAUTION:

Risk of contaminating the lubricating system.

Cover open parts of engine.

Fig 1: Cleaning Remaining Sealant With Rotating Plastic Brush

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

WARNING:

Danger of eye injury.

Wear protective eyewear.

-- Remove any remaining sealant on the timing chain cover and cylinder head using, for example, a rotating plastic brush.

-- Clean the sealing surfaces; they must be free of oil and grease.

NOTE:

Note the expiration date of the sealing compound.

Fig 2: Cut Tube Nozzle At Front Marking

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Cut the tube nozzle at the front marking (nozzle diameter: about 1.5 mm).

CAUTION:

The lubrication system could be plugged with excess sealant.

Do not apply sealant bead thicker than specified.

-- Apply a sealant bead to the clean sealing surface of the right timing chain cover as shown in the illustration.

Fig 3: Appling Sealant Bead To Timing Chain Cover -1-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The groove -1- of sealing surface must be completely filled with sealant.
The sealant bead must be 1.5 to 2.0 mm above the sealing surface.

-- Install the seal -2-.

NOTE:

Note the expiration date of the sealing compound.

Fig 4: Cut Tube Nozzle At Front Marking

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Cut the tube nozzle at the front marking (nozzle diameter: about 3 mm).

-- Apply a sealant bead with a 3 mm diameter to the transitions between the cylinder head and lower timing chain cover -arrows- as illustrated.

Fig 5: Apply A Sealant Bead

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

CAUTION:

The lubrication system could be plugged with excess sealant.

Do not apply sealant bead thicker than specified.

NOTE:

The timing chain cover must be installed within 5 minutes after applying the sealant

-- Position the right timing chain cover and tighten the bolts. Refer to Installing .

Fig 6: Identifying Right Timing Chain Cover, Tightening Specifications And Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Install in reverse order of removal. Note The Following:

-- Install the vacuum pump. Refer to OVERVIEW - VACUUM PUMP .