Reducing Agent Tank, Removing And Installing: Installing
WARNING: This page is about a different car, the 2012 Volkswagen Touareg and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
-- Raise the reducing agent tank carefully with the Engine and Gearbox Jack: VAS6931 until the wires and delivery line can be connected.
-- Position the insulation upper section on the reducing agent tank.
NOTE:
Make sure all of the components on the reducing agent tank are secure, the insulation upper section is positioned correctly and none of the lines are pinched.
-- Carefully raise the reducing agent tank using the Engine and Gearbox Jack: VAS6931 until it is possible to install the nuts.
-- Tighten the nuts to 20 Nm.
Assemble in reverse order of disassembly.
-- Install the stabilizer bar. Refer to OVERVIEW - STABILIZER BAR .
-- Fill the reducing agent tank. Refer to the appropriate Service Information.