NOx Sensor 2 -G687-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2012 Volkswagen Touareg and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the NOx Sensor 2 -G687- -1-.

Fig 1: Identifying Retainers -Arrows- And Heat Shield

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen the mounting elements -arrows- and move the heat shield to the left.

-- Disconnect the connector -1- from the NOx Sensor Control Module 2 -J881-.

-- Remove the nuts -arrows- and remove the NOx Sensor Control Module 2 -J881- and NOx Sensor 2 -G687-.

Fig 2: Identifying Nuts -Arrows-, NOx Sensor Control Module 2, And NOx Sensor 2

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.