NOx Sensor -G295-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2012 Volkswagen Touareg and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Disconnect the connector -1- from the NOx Sensor Control Module -J583-.

Fig 1: Installed Location for the Exhaust Cleaning System Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nuts -arrows- and remove the NOx Sensor Control Module -J583-.

-- Unscrew and remove the NOx Sensor -G295- -4-.

Fig 2: Identifying Installation Location Inside Exhaust System Tract

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.