Exhaust Gas Temperature Sensor 2 -G448-, REMOVING AND INSTALLING, CASA, CASD: Installing

WARNING: This page is about a different car, the 2012 Volkswagen Touareg and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specification: 45 Nm

Install in reverse order of removal while noting the following:

NOTE:

Coat the Exhaust Gas Temperature Sensor 2 -G448- threads with hot bolt paste. For the correct hot bolt paste. Refer to the Parts Information.

Note installation position:

Fig 1: Dimension -a- = 20 mm

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Dimension -a- = 20 mm between the Exhaust Gas Temperature Sensor 2 -G448- -2- and the NOx Sensor -G295- -1-.