Exhaust Gas Temperature Sensor 1 -G235-, REMOVING AND INSTALLING, CASA, CASD: Removing

WARNING: This page is about a different car, the 2012 Volkswagen Touareg and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the bolts -1- and loosen the bolt -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Move the vacuum hose and bracket -2- to the side and remove the heat shield from the turbocharger.

-- Remove the connector -3- from the bracket and disconnect it.

Fig 1: Installed Location for the Exhaust Cleaning System Connector

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Free up the wiring guide for the Exhaust Gas Temperature Sensor 1 -G235-.

-- Remove the Exhaust Gas Temperature Sensor 1 -G235- -arrow-.

Fig 2: Exhaust Gas Temperature Sensor 1 -G235- -arrow-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.