Differential Pressure Sensor -G505-, REMOVING AND INSTALLING, CASA, CASD: Installing
WARNING: This page is about a different car, the 2012 Volkswagen Touareg and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal while noting the following:
NOTE:
Make sure it is tight and there are no leaks.
If the particulate filter or the Differential Pressure Sensor -G505- was replaced, then the Differential Pressure Sensor -G505- must absolutely be adapted using the Vehicle Diagnostic Tester: Guided Functions; adapting Differential Pressure Sensor -G505-.
- Nut tightening specification: 3.5 Nm