Rear Seat Belt: Installation

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

During installation, make sure that the seat belts are not twisted.
After installation, make sure that the seat belts are smoothly extended and wound.
Check that the center seat belt is not assembled wrongly.

Install each part in the reverse order of removal.
Tightening torque:

Refer to "COMPONENT" of "General Description". < Ref. to REAR SEAT BELT , COMPONENT, General Description. >
Route the seat belt as shown in the illustration below, and affix with Velcro tape.
- LH side
  
  Fig 1: Routing Seat Belt - LH Side
  Courtesy of SUBARU OF AMERICA, INC.
- RH side
  
  Fig 2: Routing Seat Belt - RH Side
  Courtesy of SUBARU OF AMERICA, INC.
Install the seat cushion and pull out the center seat belt assembly.

Fig 3: Pulling Out Center Seat Belt Assembly
Courtesy of SUBARU OF AMERICA, INC.