LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Seat Belt System) >> Front Seat Belt >> Removal >> Outer Seat Belt Assembly

Outer Seat Belt Assembly

WARNING: This page is about a different car, the 2012 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not drop or subject the pretensioner to any impact.
  • Since the pretensioner and bracket are integrated as a unit, do not disassemble them.
  1. Before starting the work, turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 60 seconds or more.
  2. Tilt the backrest forward and move the seat to the front most position.
  3. Remove the center pillar lower trim. < Ref. to REMOVAL , Lower Inner Trim. >
  4. Remove the shoulder anchor.
    Fig 1: Anchor Cover And Shoulder Anchor Bolt
    G07681276Courtesy of SUBARU OF AMERICA, INC.
    1. Remove the anchor cover (A).
    2. Loosen the shoulder anchor bolt (B), and then detach the shoulder anchor from center pillar.
  5. Disconnect the connector of the belt tension sensor on passenger's seat.
  6. Turn over the floor mat to disconnect the belt tension sensor connector.
  7. Remove the three bolts to remove the seat belt retractor.
    Fig 2: Locating Seat Belt Retractor Bolts
    G07681277Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the center pillar upper trim. < Ref. to REMOVAL , Upper Inner Trim. >
  9. Remove the two bolts to remove the adjustable anchor assembly.
    Fig 3: Locating Adjustable Anchor Assembly Bolts
    G07681278Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals