Engine Mount, Removing And Installing: Removing

WARNING: This page is about a different car, the 2012 Volkswagen Touareg and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the bolts and the front -1- and rear -2- noise insulation.

Fig 1: Identifying Front/Rear Noise Insulation

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove air guide hose -arrows-.

Fig 2: Charge Air Hose Clamps -Arrows- And Hose

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove engine bracket nuts at left and right -arrow-.

Fig 3: Identifying Engine Mount Bracket To Engine Mount Nut -Arrow-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove engine bracket screws at left and right -arrows-.

-- Hold the engine in its installed position. Refer to ENGINE, SUPPORTING IN INSTALLED POSITION

-- Raise engine until engine supports are above engine bracket threaded pins and evenly tension both spindles to achieve even weight distribution.

-- Remove left and right engine bracket.

Fig 4: Identifying Engine Bracket Bolts At Left And Right

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.