Engine, Securing To Engine And Transmission Holder :Vas6095: Procedure

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Separate the engine and the transmission. Refer to ENGINE AND TRANSMISSION, SEPARATING .

-- After separating engine from transmission, secure the torque converter to prevent it from "falling out".

-- Engage the :3033 as follows and remove the engine from the :VAS6131 using the :VAS6100 :

Fig 1: Hooking Engine Sling 3033 Onto Engine And Onto Workshop Crane VAS 6100

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Vibration damper side: position 3.

Flywheel side: Position 11

NOTE:

Threaded spindles are set in length according to necessity.

Secure Engine to :VAS6095

Fig 2: Identifying Engine And Transmission Holder VAS 6095

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Secure the engine on the : VAS6095 as shown.

Secure Engine on : 3269

Fig 3: Identifying Engine Support 3269 Tightly Bolted To Cylinder Block

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the right engine support.

-- Tighten the engine on the :3269 as shown.