Relay And Fuse Panel 1 -SR1-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Always follow the procedure in the service information when disconnecting the battery. The battery cut-out will be deactivated and damage to the vehicle electrical equipment may occur if the connecting sequence is not followed exactly. Refer to BATTERY .

-- Disconnect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the bracket for the Comfort System Central Control Module -J393-. Refer to COMFORT SYSTEM CENTRAL CONTROL MODULE -J393- BRACKET, REMOVING AND INSTALLING .

NOTE:

It is necessary to remove the fuse panel on the driver side because there is a wiring harness behind it. The wires can remain connected to the fuse panel.

-- Remove the fuse panel on the driver side. Refer to FUSE HOLDER, REMOVING AND INSTALLING .

-- Remove the 3 screws -1- and lower the gateway control module bracket -2-. Pay attention to the wires still connected.

Fig 1: Identifying Removal Of Screws -1- To Lower Gateway Control Module Bracket -2-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Open the retainers -arrows- and remove the relay panel -1-.

Fig 2: Identifying Retainers -Arrows- And Relay Panel -1-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.