Connection/Conjunction Box -SX3- With Fuse Panel D -SD-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the bolt -1-, disconnect the 3 connectors -2- and remove the cover -3-.

Fig 1: Identifying Bolt -1-, Connectors -2- And Cover -3-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nut -2-.

Fig 2: Identifying Fuse Panel Cover -1-, Nuts -2 To 3- And Wires -4-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nuts -3- (depending on the vehicle equipment level) and wires -4-.

-- Open the latches -arrows- and remove the cover from Fuse Panel D -SD- -1-.

NOTE:

If necessary, mark the equipment dependent allocation of individual wires to connection points in Connection and Junction Box 3 -SX3-.

-- Loosen threaded connections and remove all wires from the Connection and Junction Box 3 -SX3- connections.

Fig 3: Identifying Back Up Fuse Box Mounting Nuts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the nuts -arrows- and the Connection and Junction Box 3 -SX3- from the vehicle.