Reversible Seat Belt TENSIONER, Replacing Control Module, Guided Fault Finding

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Vehicles with "PR number 4QE" have front seat belts equipped with a reversible belt tensioner.

If a front seat belt with a reversible belt tensioner is replaced, operate the control module integrated in the automatic belt retractor via "Guided Fault Finding".

Component protection deactivated

Required Special Tools and Equipment

Vehicle Diagnostic Tester

Right Front Seat Belt

-- Connect the Vehicle Diagnostic Tester to the vehicle.

-- Start "Guided Fault Finding".

After all control modules have been checked:

-- Open "Select individual test..." under "Test plan".

-- Select "Body".

-- Select "Body Repairs".

-- Select "01 - On board diagnostic-capable systems".

-- Select "90 - Right front belt tensioner".

-- Select "90 - Right front belt tensioner, functions".

-- Select "90 - Replace control module".

-- Run the component protection function if it does not happen automatically.

Left Front Seat Belt