Overview - Passenger Occupant Detection
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
The passenger occupant detection system service kit is precalibrated and must not be disconnected. The service kit consists of:
- Passenger Occupant Detection System Control Module -J706-
- Passenger Occupant Detection System Pressure Sensor -G452-
- Passive Occupant Detection System Mat
- Seat cushion
WARNING:
Follow all Safety Precautions when working on the passenger occupant detection system. Refer to PASSENGER OCCUPANT DETECTION SYSTEM SAFETY PRECAUTIONS .
NOTE:
The passenger occupant detection system is only installed in the front passenger side.
- Passenger Occupant Detection System Pressure Sensor -G452-
- Is a component of the passenger occupant detection system mat
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- The connector may be disconnected for removing and installing
- Seat Pan
- Retaining Clip
- Cushion
- For the lower seat frame
- Do not separate from the passenger occupant detection system mat -6-
- Retaining Clip
- Do not release.
- Mat
- For the passenger occupant detection system
- Is a component of the Passenger Occupant Detection System Pressure Sensor -G452-
- Do not separate from the lower seat frame cushion -4-
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Mount
- For the Passenger Occupant Detection System Control Module -J706-
- Expanding Pin
- For securing the mount to the lower seat frame
- Wiring Harness
- Can be disconnected from Passenger Occupant Detection System Pressure Sensor -G452- and Passenger Occupant Detection System Control Module -J706-
- Front Passenger Seat Position Sensor -G554-
- Is a component of the wiring harness -9-
- Removing and installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING .
- Passenger Occupant Detection System Control Module -J706-
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- The connector may be disconnected.