Front Passenger Occupant Detection Sensor -G128-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the seat. Refer to SEAT, REMOVING AND INSTALLING .

-- Remove the seat belt latch. Refer to FRONT SEAT BELT LATCHES, REMOVING AND INSTALLING .

-- Remove the tunnel-side trim. Refer to TUNNEL-SIDE TRIM, REMOVING AND INSTALLING .

-- Remove the sill-side trim. Refer to SILL-SIDE TRIM, REMOVING AND INSTALLING .

-- Remove the drawer. Refer to DRAWER, REMOVING AND INSTALLING .

-- Remove the bracket for the sill-side trim. Refer to SILL-SIDE TRIM BRACKET, REMOVING AND INSTALLING .

-- Remove the seat cover and cushion. Refer to SEAT COVER AND CUSHION, REMOVING AND INSTALLING .

WARNING:

The Front Passenger Occupant Detection Sensor -G128- -1- is glued to the seat cushion. Separate removal and installation are not possible. The sensor must be replaced with the seat cushion.

Fig 1: Identifying Front Passenger Seat Occupant Sensor (1 Of 2)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.