Service Test, Performing

WARNING: This page is about a different car, the 2017 Volkswagen Touareg and 2010 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The Printed Test Results Can Differ Depending On The Software Version.

Read the Battery Tester:VAS6161 Operating Instructions.

WARNING:

Do not check or charge batteries that have a visual indicator that is bright yellow. Jump starting must not be used!

There is a risk of explosion during testing, charging or jump starting.

These batteries must be replaced.

-- Select "Service Test".

-- Select "at the battery pole" or "at the battery jump start terminal".

-- Select the type of battery: "standard", "AGM", "2*6V" or "Gel".

-- Select the "CCA", "JIS", "DIN", "SAE", "IEC" or "EN".

-- Select battery value.

-- Measure the temperature. Hold the temperature sensor approximately 5 cm above the battery pole until the temperature is stable.

-- Start the test.

-- Print out the test report if necessary.