Fuel Tank With Attachments, Removing And Installing: Notes
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Fuel Extraction Unit:VAS5190
- Wrench - Fuel Sending Unit:T10202
- Torque Wrench 1331 5-50Nm:VAG1331
- Torque Wrench 1332 40-200Nm:VAG1332
- Engine and Gearbox Jack:VAS6931
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Seal - Fuel pump
CAUTION:
During all repair procedures on the fuel tank, be aware of the following:
- Route all the various lines (for example for fuel, Evaporative Emission (EVAP) system, or vacuum) and electrical wiring so that the original routing positions are restored.
- Make sure that the Ground (GND) wire between the fuel filler tube and body is securely fastened, to prevent electrostatic charging.
- Ensure sufficient clearance to all moving or hot components.
Requirements
- The fuel tank must be empty. Refer to FUEL TANK, DRAINING .