Brake Caliper, Removing And Installing: Removing
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Torque Wrench 1332 40-200 Nm :VAG1332
- Brake Pedal Actuator:VAG1869/2 .
Work procedure applies only for replacing or when performing subsequent service work on brake caliper.
-- Remove the rear wheels.
-- Connect bleeder hose of bleeder bottle to bleeder valve of brake caliper and then open bleeder valve.
-- Insert the Brake Pedal Actuator:VAG1869/2 .
-- Close bleeder valve and remove the bleeder bottle.
-- Disconnect the connector for brake pad wear indicator.
-- Remove the brake pad wear display wire from the brake caliper.
-- Remove brake line from brake caliper.
-- Remove brake caliper from wheel bearing housing.
-- Remove the brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING .