Brake Lamp Switch -F-, Removing And Installing, RHD Vehicle: Removing
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the engine compartment seal near the brake booster.
-- Remove the right plenum chamber cover. Refer to PLENUM CHAMBER BULKHEAD .
-- Release and disconnect the connector -2- on the Brake Lamp Switch -F- -1-.
-- Remove the bolt from the brake master cylinder.
-- Remove the Brake Lamp Switch -F- -1- from the brake master cylinder at the top and then remove it from the clip at the bottom.