Test Requirements
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
- Suspension, wheel bearing, steering and steering linkage checked for excessive play and damage.
- Tread depth difference may be no more than 2 mm on an axle.
- Tires inflated to the inflation pressure.
- Vehicle curb weight
- Fuel tank must be full.
- Spare tire and vehicle tools are installed in appropriate position in vehicle.
- The water container for the windshield/headlamp cleaning system must be full.
- Make sure that the sliding plate and turntable are not touching the end stop during the measurement.
NOTE:
- Test equipment must be properly attached and adjusted; observe equipment manufacturer instructions!
If necessary, contact the manufacturer of the wheel alignment device for instructions.
After a certain period, wheel alignment platforms and computer equipment can lose their original leveling setting and adjustments.
Wheel alignment platforms and wheel alignment analyzer/computer should be serviced and calibrated at least once a year.
-- Handle highly sensitive units with care.