LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1223 (Wheels, Tires, Wheel Alignment (Suspension, Wheels, Steering)) >> 44 Wheels, Tires, Wheel Alignment >> Wheel Alignment >> Overview - Wheel Alignment Procedure >> Measuring Procedure

Measuring Procedure

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
                 
  Start Perform wheel run-out compensation. Bounce the vehicle  
               
  Turn the steering wheel into the straight ahead position and secure it (1) Measure the vehicle height Insert the Brake Pedal Actuator:VAG1869/2  .  
               
  Check camber at front axle Is the actual value within tolerance? No  
             
    Yes   Adjusting. Refer to FRONT AXLE CAMBER, ADJUSTING .  
             
     
               
  Check rear axle camber Is the actual value within tolerance? No  
             
    Yes   Adjusting. Refer to REAR AXLE CAMBER, ADJUSTING .  
             
     
               
  Check toe at rear axle Is the actual value within tolerance? No  
             
    Yes   Adjusting. Refer to REAR AXLE TOE, ADJUSTING .  
             
     
               
  Check caster at front axle Is the actual value within tolerance? No  
             
    Yes   Adjusting. Refer to FRONT AXLE CASTER, ADJUSTING .  
             
     
               
  Check toe at front axle Is the actual value within tolerance? No  
             
  End Yes   Adjusting. Refer to FRONT AXLE TOE, ADJUSTING .  
             
     
(1) If steering wheel is crooked at end of alignment procedure, it must be straightened. Then perform the basic setting for the Steering Angle Sensor -G85- with the Vehicle Diagnostic Tester.