General Information: Notes
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Wheel Alignment Computer:VAG1813 or VW/Audi approved wheel alignment devices
- Brake Pedal Actuator:VAG1869/2 .
- Insert Tool - 18mm:T10179
- Shock Absorber Set:T10001
Wheel alignment must only performed using VW/Audi-approved wheel alignment equipment!
Wheel alignment checks must always include both the front and rear axles.
Otherwise the center position of steering rack cannot be guaranteed!
-- Perform the alignment using the wheel alignment computer.
All information required for an alignment is stored in the wheel alignment computer.
NOTE:
Wheels should not be aligned until the vehicle has been driven 1,000 to 2,000 km, since it takes this long for the coil springs to settle.
The individual specifications should be followed as precisely as possible when making adjustments.
A Wheel Alignment is Necessary if:
- Vehicle shows handling problems.
- There is accident damage and components were replaced.
- Axle components have been removed or replaced.
- Tire wear patterns are uneven.