Lane Assist, General Information

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Detailed Information Regarding the Directional Stabilization Assistance is Available in appropriate service information.

NOTE:

If the camera can no longer recognize the lane markings due to poor visibility, this could be caused by:

The camera visual field is dirty or icy. If that is the problem, it should be corrected.
The camera view field in fogged over.
Due to the condition of the road (for example, the road is covered with snow or there is construction), there are no clear lane markers.

If the Camera Lens is Obstructed by a Lot of Dirt on the Inside, Then Lens Must Be Cleaned By Hand. To Do This, Remove the Control Module and the Lens and Clean the Windshield Using the Cleaning Solution. Remove the Control Module and Lens Screen. Refer to REARVIEW CAMERA (REAR ASSIST) .

For the Lane Assist to Function Correctly, it is Absolutely Necessary that the Calibration be Correct.

The Lane Assist Must Be Re-Calibrated for the Following Reasons:

"No or incorrect basic setting/adaptation" is stored in the event memory.
The Camera Control Module -J852- was replaced.
The windshield was replaced or removed.
The rear axle toe was adjusted.
Work was performed on the chassis which influences the body height.

NOTE:

Before calibrating the directional stabilization assistance, check the event memory and correct any malfunctions.

To calibrate the lane assist, the geometric drive axle of the vehicle must be determined. It serves as a reference point for the Setting Device Basic Set :VAS6430/1 .

The lane assist must only be calibrated using alignment equipment approved by VW/Audi!

Only use the Setting Device Basic Set:VAS6430/1 to calibrate the lane assist.