Assembly Instructions

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Warm the name badge before removing using the Hot Air Blower: VAG1416 .
If installing the cover strip for the first time on a commercial vehicle or a newly painted surface, follow the procedure described in 00 GENERAL, TECHNICAL DATA .
When removing and installing the name badge, only use the Adhesive Remover: D 002 000 10 to remove the adhesive residue.
If necessary, remove any adhesive residue left by the tape using Adhesive Strip Remover: VAS6349 .
Make sure the adhesive surfaces are free of dust and grease.
Apply the name badges immediately after cleaning them.
Only remove the protective film right before assembly.
The temperature must be approximately 21 °C (70 °F).
It is not possible to remove the name badge without breaking it.