Steering Column Switch Module, Removing And Installing: Removing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Do not turn the spiral spring on the Steering Column Electronics Control Module -J527- from its center position during removal. The front wheels must be in the straight ahead position.

-- Lower the steering all the way down and pull it out all the way.

CAUTION:

Always follow the procedure in the Service Information when disconnecting the battery. The battery cut-out will be deactivated and damage to the vehicle electrical equipment may occur if the connecting sequence is not followed exactly. Refer to BATTERY .

-- Disconnect the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove The Driver Side Airbag Unit. Refer to DRIVER SIDE AIRBAG UNIT, REMOVING AND INSTALLING .

-- Remove the steering wheel. Refer to AIRBAG STEERING WHEEL, REMOVING AND INSTALLING .

-- Remove The Steering Column Trim Panel. Refer to STEERING COLUMN TRIM, REMOVING AND INSTALLING .

-- Disengage and disconnect harness connectors -2 and 3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- To release the connector -3- press the connector lock -1- in direction of -arrow-, until the connector -2- unlocks.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Loosen the clamping screw and remove the steering column switch module from the steering column.