Rear Peripheral Camera -R246- Calibrating

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

First perform the calibration requirements. Refer to REQUIREMENTS FOR CALIBRATING .

Then perform the preparation work for calibrating the Rear Peripheral Camera -R246-. Refer to Rear Peripheral Camera -R246-, PREPARING FOR CALIBRATION .

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER .

-- In the Vehicle Diagnostic Tester, select "guided fault finding" .

-- Using the "Go to" button, select the "function/component selection" and the following menu options in sequence:

Body
Electrical Equipment
01 - OBD-capable systems
6C - Rearview camera system J928
6C - Rearview camera system, functions
6C - Coding the peripheral camera

From here, continue with the calibration on the Vehicle Diagnostic Tester.