Parking Aid Control Module -J446-, Output Diagnostic Test Mode
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
The Parking Aid Control Module -J446- is located under the instrument panel inside the footwell on the driver side.
The following components can be checked via output diagnostic test mode:
- Right Front Parking Aid Sensor -G252-
- Right Front Center Parking Aid Sensor -G253-
- Left Front Center Parking Aid Sensor -G254-
- Left Front Parking Aid Sensor -G255-
- Left Rear Parking Aid Sensor -G203-
- Left Rear Center Parking Aid Sensor -G204-
- Right Rear Center Parking Aid Sensor -G205-
- Right Rear Parking Aid Sensor -G206-
- Rear Parking Aid Warning Buzzer -H15-
- Front Parking Aid Warning Buzzer -H22-
- Parking Aid Control Module -J446-
-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER .
-- In the Vehicle Diagnostic Tester, select "Guided Fault Finding" .
-- Using the "Go to" button, select the "Function/Component Selection" and the following menu options in sequence:
- Body
- Body repair procedures
- 01 - On Board Diagnostics (OBD)-capable systems
- 10 - Parking Aid Control Module -J446-
- 10 - Parking aid control module II functions
- 10 - Output diagnostic test mode