Lane Change Assistance Control Module -J769- / Lane Change Assistance Control Module 2 -J770-, Calibrating: Procedure

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Switch on the -VAS6350/4- at the power switch -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The green Light Emitting Diode (LED) -1- must light up.

NOTE:

If the red LED -2- illuminates: Check the -VAS6350/4-.

-- Connect the Vehicle Diagnostic Tester. Refer to VEHICLE DIAGNOSTIC TESTER .

-- In the Vehicle Diagnostic Tester, select "Guided Fault Finding" .

-- Using the "Go to" button, select the "Function/Component Selection" and the following menu options in sequence:

Body
Body repair procedures
01 - On Board Diagnostics (OBD) - capable systems
3C - -J769-
3C - Lane change assistance functions
3C - Calibration

-- Follow the instructions on the Vehicle Diagnostic Tester display.

During the course of the program, a request is made to switch the -VAS6350/4- from the left to the right side of the :VAS6350 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Switch the -VAS6350/4- off and move device.

When installed correctly, vehicle electrical system voltage line must be connected at bottom left of calibration device (as seen in direction of travel).
Dimension -a- = 850 mm (measured from upper edge of calibration device to floor).
Right setting = 815 mm (read on measurement scale -1-).

-- Switch on the -VAS6350/4- at the power switch -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The green LED -1- must light up.

-- Follow the instructions on the :Vehicle Diagnostic Tester display.

After successful lane change assistance calibration, switch the ignition off and disconnect the diagnostic connector.