Lane Change Assistance Control Module -J769- / Lane Change Assistance Control Module 2 -J770-, Calibrating: Notes
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Calibration Tool :VAS6350
- Vehicle Diagnostic Tester
The left Lane Change Assistance Control Module -J769- (master) or right Lane Change Assistance Control Module 2 -J770- (slave) is combined in one unit with the radar sensor for the respective side. They are located behind the rear bumper cover and must be calibrated after:
- Removal and installation of the bumper cover
- Removal and installation of one or both lane change assistance control modules
- Each time the installation location of a lane change assistance control module is changed
There is much preparation work that must be performed before calibrating using the Vehicle Diagnostic Tester. Refer to PREPARING FOR CALIBRATION .
NOTE:
Before the actual calibration procedure for the lane change assistance control modules, the :VAS6350 must be set up as described in service information.
The Following Should Not Occur During The Calibration Procedure:
- Vehicle doors must not be opened or closed.
- People should not sit in the vehicle.
- People must not go between the vehicle and the -VAS6350/4-.