Camera Control Module -J852-, Calibrating
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
The Lane Assist System Must Be Calibrated Under The Following Conditions:
- The fault Camera Control Module -J852-, "no or incorrect basic setting/adaptation" is present in the Diagnostic Trouble Code (DTC) memory.
- The Camera Control Module -J852- was replaced.
- The windshield was removed or replaced.
- The rear axle toe was adjusted.
- Modifications were performed on the suspension which affect vehicle height.
- One of the vehicle level control system sensors -- on vehicles with damping regulation or air suspension was adapted.
Camera Control Module - J852- calibrating. Refer to LANE ASSIST, CALIBRATING .